Rhombicosi-dodecahedron
Say it, don’t spray it.
Supplies you’ll need
This is not an electronics or circuitry project, so there’s no electronics know-how or soldering required. The only thing you’ll need is access to a 3D Printer and a few hand tools!
1.75mm PLA filament
Used for the main shapes, but also for the hinge pins. Have some extra ready after printing!
PLA or PETG filament recommended.
2mm drill bit (with drill)
A hand drill would work just fine, but a power drill gives you more control for smoothing out the pin holes for the hinges. Hand drill shown.
Patience
Printing the pieces is a time-consuming process, so unless you operate a printer farm or have seven printers, these may take a while!
I recommend using max 0.3mm layer height for the shapes, max 0.2 for the hinges.